2020 Hyundai Veloster Oil Filter in Peoria, AZ

Yes, the oil filter is replaced with every oil change to keep the 2020 Hyundai Veloster circulating filtered oil.

The filter captures debris the oil carries away; as it fills, the bypass valve opens and oil flows unfiltered, which quietly increases wear. Replacing the filter at each service restores full filtration capacity and helps maintain stable oil pressure. Follow the manufacturer’s schedule and your driving conditions when planning service.

• New, engine-matched filter installed
• Fresh oil filled to the correct level
• Warm-engine leak check performed

The service includes removing the old filter, renewing sealing surfaces, installing an engine-matched filter, and verifying the result with a warm-engine leak check.

On a 2020 Hyundai Veloster, we also drain the used oil, refill with the oil grade the manufacturer specifies for this engine, and confirm proper oil pressure after start-up. The maintenance reminder is reset when applicable, and the work is documented for your records.

• Seals/gasket cleaned and renewed
• Filter torqued to spec and checked
• Oil level verified after engine run

The filter loads with debris, its bypass valve opens, and the engine receives unfiltered oil that can increase wear over time.

Unfiltered oil still lubricates, but abrasive particles circulate through bearings and valvetrain surfaces, undermining long-term durability. Skipping the filter also risks leaks if old seals harden. Replace the filter with the oil change to keep protection consistent.

• Higher contamination in circulating oil
• Potential for gradual, unnoticed wear
• Increased chance of seepage at old seals

Yes, the filter is matched to the 2.0-liter, 4-cylinder engine and filters are not interchangeable across engines.

Correct fit and flow characteristics ensure proper sealing and stable oil pressure. Using a non-matched filter can affect filtration performance or bypass behavior. During service, we install a filter designed for this engine and verify results with a leak check.

• Engine-matched dimensions and media
• Correct bypass valve characteristics
• Proper baseplate and gasket fit

It can be done, but it is not recommended because the loaded filter can trigger bypass and circulate unfiltered oil.

Leaving an old filter in place limits debris-holding capacity for the new oil and can shorten its service life. Replacing both together keeps filtration consistent and supports steady oil pressure. Follow the manufacturer’s schedule and adjust for severe-use driving.

• Replace oil and filter as a set
• Helps preserve new oil quality
• Reduces quiet, cumulative wear

Book online with our schedule service tool or call the store for help.

Choose a time, note your 2020 Hyundai Veloster, and we’ll prepare the correct filter and supplies. You can also review current service specials before confirming your visit. Online scheduling is available 24/7.

• Pick your date and time online
• Add notes about symptoms or requests
• Receive appointment confirmation