2020 Hyundai Santa Fe Oil Filter in Peoria, AZ

Yes—the oil filter is replaced with each oil change to keep debris from circulating back through the engine.

The filter captures particles the oil carries away; once the element loads, its bypass valve opens and oil circulates unfiltered, which quietly increases wear. Replacing the filter with the oil restores both clean lubricant and full filtration performance. Follow the manufacturer’s schedule and your driving conditions to determine timing.

• New, correctly matched filter installed at each change
• Bypass valve risk avoided by not reusing a loaded filter
• Service timing guided by the manufacturer and driving style

The service includes draining oil, removing the old filter, fitting a matched new filter, renewing sealing surfaces, refilling with the specified oil grade, and leak checks.

Technicians clean the filter base, install a fresh gasketed filter, and renew the drain plug sealing surface. After refill, the engine is run to verify pressure and inspect for seepage at the filter and plug. The level is rechecked and the maintenance reminder is reset where applicable.

• Matched filter for proper flow and bypass function
• Sealing surfaces cleaned; gasket seated correctly
• Warm‑engine inspection confirms no leaks

A loaded filter can trigger its bypass valve, sending unfiltered oil through the engine and increasing wear over time.

Filtration efficiency drops as debris accumulates, and once the bypass opens, contaminants no longer get trapped. The engine still receives oil, but it’s not filtered—an issue that rarely makes noise yet accelerates internal wear. Replacing the filter at each oil change avoids this silent risk.

• Bypass valve allows unfiltered flow under restriction
• Quiet increase in wear, especially in tight‑tolerance parts
• Fresh filter restores debris‑holding capacity

Yes—the filter is matched to the 2.0‑liter inline 4‑cylinder engine, and filters are not interchangeable across engines.

Correct fit ensures proper sealing, flow rate, filtration area, and bypass valve calibration. Using a mismatched filter can compromise oil pressure or allow unfiltered oil to circulate under load. Our service team installs a filter that matches this engine’s requirements without guessing part numbers.

• Engine: 2.0L inline-4 requires a matched filter
• Right bypass behavior protects under high load
• Proper gasket size prevents leaks after warm‑up

It can be done, but it is not recommended because a partially loaded filter can send unfiltered oil through the bypass valve.

Changing oil while leaving an old filter in place keeps debris trapped in the element and risks bypass if the media is restricted. Best practice is to replace the filter at every oil change so fresh oil is paired with restored filtration capacity. Follow the manufacturer’s maintenance guidance for timing.

• Fresh oil deserves a fresh filter for full protection
• Bypass risk rises as filters load with debris
• Consistent pairing simplifies records and planning

Use our online tool to schedule appointment or call the store for assistance.

Online booking lets you choose a time, note your 2020 Hyundai Santa Fe, and see available service specials. Prefer to talk it through? Call our advisors to align your visit with your driving needs in Peoria and the Phoenix West Valley.

• Fast online scheduling 24/7
• View current service offers before you book
• Phone support if you have questions about your visit