2017 Hyundai Elantra GT Oil Filter in Peoria, AZ

Yes—the oil filter is replaced at each oil change so fresh oil isn’t pushed through a loaded filter.

The filter captures debris the oil carries away; as it fills, the bypass valve opens so oil can flow unfiltered to protect pressure. Unfiltered oil quietly increases wear, defeating the purpose of fresh oil. Replacing the filter with the oil resets the cleaning cycle and reduces the chance the bypass opens.

• Fresh oil plus a new filter keeps contaminants from recirculating.
• Prevents the filter’s bypass valve from routing unfiltered oil.
• Supports consistent oil pressure and protection.

The old filter is removed, sealing surfaces are renewed and cleaned, a matched filter is installed, and a post‑run leak check is performed.

During service, the technician drains the oil, installs a new filter designed for this engine, and refreshes the drain plug seal as needed. After filling with the oil grade the manufacturer specifies, the engine is run at idle and checked for leaks and proper level. Maintenance indicators are reset when applicable.

• Matched filter installed and gasket land cleaned.
• Drain plug sealing surface or washer renewed.
• Engine run and inspected for leaks, level verified.

The filter can load with debris, trigger its bypass valve, and allow unfiltered oil to circulate, increasing internal wear over time.

A saturated filter restricts flow; to protect pressure, the bypass opens and the engine receives oil that is not filtered. While you may not notice an immediate symptom, contaminants can accelerate wear in bearings and valvetrain components. Replacing the filter at each oil change helps maintain protection.

• Bypass valve opens when the filter is loaded.
• Unfiltered oil quietly increases component wear.
• Fresh filter restores full filtration efficiency.

Yes—the filter is matched to the 2.0‑liter, 4‑cylinder engine and filters are not interchangeable across different engines.

Filter dimensions, sealing surfaces, media, and bypass settings vary by engine design. Using a filter built for this 2.0‑liter inline‑4 ensures proper fitment, sealing, and flow characteristics. At service, we install a filter that meets the requirements for this engine without citing part numbers.

• Correct fit and gasket sealing for this engine family.
• Bypass and flow rates tuned to engine needs.
• Prevents leaks and ensures reliable oil pressure.

It can be done, but it’s not recommended because the old filter can force the bypass to open and recirculate unfiltered oil.

Skipping the filter leaves trapped debris in place, contaminating your fresh oil as soon as the engine runs. Any restriction in the old filter makes the bypass more likely to open, eliminating filtration when protection matters most. Replace the filter with the oil to maintain consistent cleanliness.

• Old filter immediately contaminates new oil.
• Bypass risks unfiltered circulation under load.
• Best practice: replace oil and filter together.

Use our online portal to schedule service or call {{rooftop.phone}} for help.

Choose a time that fits your day, add your 2017 Hyundai Elantra GT details, and we’ll prepare the correct filter for your visit. You can also review current service specials before booking. On appointment day, arrive at 8425 W Bell Rd, Peoria, AZ 85382.

• Book online in minutes with your vehicle info.
• View available times and transportation options.
• Confirm and receive appointment reminders.