2013 Hyundai Tucson Oil Filter in Peoria, AZ

Yes—replace the oil filter every time you change the oil on a 2013 Hyundai Tucson.

The filter holds debris the oil has picked up; leaving it in place risks pushing trapped particles back into circulation. Once a filter loads, its bypass valve opens so oil flows but is no longer filtered, which defeats the purpose of fresh oil. Replacing both together keeps filtration effective and helps maintain stable oil pressure.

• Prevents old debris from contaminating fresh oil
• Maintains filtration when the bypass valve would otherwise open
• Supports consistent oil pressure and engine protection

The service includes removing the old filter, renewing sealing surfaces, installing a filter matched to this engine, and leak-checking after the engine runs.

We clean the mounting base, lubricate the new gasket, and torque components appropriately. Fresh oil—of the manufacturer-specified grade—is added, the engine is started, and we inspect the filter and drain plug for seepage. The level is rechecked and the maintenance reminder is reset as applicable.

• New, engine-matched oil filter installed
• Fresh drain plug sealing surface fitted and leak check performed
• Oil level verified after a run-up and indicator reset as applicable

The filter can load up, trigger the bypass valve, and allow unfiltered oil to circulate through the engine.

Unfiltered oil quietly increases wear because abrasive particles no longer get trapped. Old filters can also weep at the gasket if the sealing surface hardens or is disturbed. Skipping the filter undermines the value of fresh oil and can lead to stability issues with oil pressure over time.

• Bypass valve opens under restriction, ending filtration
• Increased particle circulation and potential wear
• Higher chance of gasket seepage or leaks

Yes—the filter must be matched to the 2.4-liter 4-cylinder engine; filters are not interchangeable across engines.

A correct filter ensures proper fitment, sealing, flow, and bypass valve calibration for the 2.4L inline-four. Using a mismatched filter can compromise filtration and oil pressure control. Our team installs a filter that matches this engine’s specification without guessing at part numbers.

• Engine-specific fit and gasket sealing
• Bypass valve calibrated for the 2.4L 4-cylinder
• Correct flow characteristics for stable oil pressure

It can be done, but it is not recommended because the old filter can let debris recirculate or force unfiltered flow via the bypass valve.

Changing oil alone leaves a loaded filter in place, which can negate much of the benefit of fresh oil. The safest practice is to replace both together at the interval determined by the manufacturer and your driving conditions. That restores filtration and helps protect the engine between services.

• Old debris can contaminate new oil
• Bypass valve may open, ending filtration
• Best practice: replace oil and filter together

Use our online portal to schedule appointment or call the service team to book your visit.

Pick a time that fits your day, then check our service specials before you arrive. We’ll install a filter matched to your 2013 Hyundai Tucson and verify sealing surfaces and leaks after the engine runs. If you prefer, you can also visit our service center page to learn more.

• Schedule online in minutes
• Browse current service specials
• Get dealership-installed, engine-matched parts